Atkinson index: Difference between revisions
en>Rjwilmsi m Format plain DOIs using AWB (8079) |
en>Addbot |
||
| Line 1: | Line 1: | ||
{{orphan|date=September 2008}} | |||
'''Voltage [[Droop_(control)#Droop|droop]]''' is the intentional loss in output [[voltage]] from a device as it drives a load. Employing droop in a [[Voltage regulator|voltage regulation circuit]] increases the headroom for load transients. | |||
Although it may seem counterproductive, a series resistor is included between the regulator output and the load. The resistance needs to be chosen so that at maximum output current, the output voltage at the load is the minimum acceptable. Conversely, when the output current is (near) zero, the voltage is near the maximum. This follows simply from [[Ohm's law]]. The behaviour of the system with and without the added droop resistor is as follows: | |||
[[Image:Droop behaviour.png]] | |||
In a regulator not employing droop, when the load is suddenly increased very rapidly (i.e. a transient), the output voltage will momentarily sag. Conversely, when a heavy load is suddenly disconnected, the voltage will show a peak. The output decoupling capacitors have to "absorb" these transients before the loop has a chance to compensate. A diagram of such transients is shown below. The maximum allowed voltage swing in such a transient is <math>V_{max} - V_{nom}</math>. | |||
[[Image:Regulator no droop.png]] | |||
Comparing this to a regulator with droop, we find that the maximum allowed swing has doubled: it is now <math>V_{max} - V_{min}</math>. This increased tolerance to transients allows us to decrease the number of output capacitors, or get better regulation with the same number of capacitors. | |||
[[Image:Regulator droop.png]] | |||
==References== | |||
*[http://www.maxim-ic.com/appnotes.cfm/appnote_number/993 Maxim-IC application note] | |||
*[http://www.canadiancontrols.com/documents/technical/Speed%20Droop%20and%20Power%20Generation.pdf speed droop and power generation] | |||
*Intersil Application Note 1021 (June 2002) | |||
[[Category:Electrical parameters]] | |||
[[Category:Electronics]] | |||
Revision as of 10:44, 15 March 2013
Voltage droop is the intentional loss in output voltage from a device as it drives a load. Employing droop in a voltage regulation circuit increases the headroom for load transients.
Although it may seem counterproductive, a series resistor is included between the regulator output and the load. The resistance needs to be chosen so that at maximum output current, the output voltage at the load is the minimum acceptable. Conversely, when the output current is (near) zero, the voltage is near the maximum. This follows simply from Ohm's law. The behaviour of the system with and without the added droop resistor is as follows:
In a regulator not employing droop, when the load is suddenly increased very rapidly (i.e. a transient), the output voltage will momentarily sag. Conversely, when a heavy load is suddenly disconnected, the voltage will show a peak. The output decoupling capacitors have to "absorb" these transients before the loop has a chance to compensate. A diagram of such transients is shown below. The maximum allowed voltage swing in such a transient is .
Comparing this to a regulator with droop, we find that the maximum allowed swing has doubled: it is now . This increased tolerance to transients allows us to decrease the number of output capacitors, or get better regulation with the same number of capacitors.
References
- Maxim-IC application note
- speed droop and power generation
- Intersil Application Note 1021 (June 2002)